1A DRV8833 Dual Motor Driver Module Full-bridge Driver for Arduino

The motor driver can control up to two DC motors at a constant current of 1.0A (4A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz.Note: However, when using the board at currents up to 0.6A, it may be necessary to improve thermal performance with a heat-sink.Features:- Driver Chip: DRV8833- Power supply voltage: VM = 2.7-10.8V- Output current: Iout=1.0A(average) / 4A (peak)- Standby control to save power- CW/CCW/short brake/stop motor control modes- Built-in thermal shutdown circuit and low voltage detecting circuit- All pins of the DRV8833 break out to 2.54mm spaced pins, and it can be plugged onto the breadboard.- Filtering capacitors on both supply lines- Great for DIY and smart car projectsGeneralBrandOPEN-SMARTModelN/AQuantity1 pieceForm ColorBlackMaterialPCBSpecificationEnglish Manual / SpecYesDownload Link https://drive.google.com/drive/folders/0B6uNNXJ2z4CxZUtfRzZ5bTdoZzg?usp=sharingPacking List1 * ModulePackage Weight:0.003kg (0.007lb)Package Size:5.5cm x 3cm x 2.1cm (1.97in x 1.18in x 0.79in)